terewcloud.blogg.se - Virtual port driver stm windows 10

VIRTUAL PORT DRIVER STM WINDOWS 10 PC
VIRTUAL PORT DRIVER STM WINDOWS 10 WINDOWS

The Default gateway should be the same as in Step 4, except the last number should be 1, i.e. The IP address should be the same as at Step 4, except the last number which should be different (e.g. Select “Use the following IP address” and enter a specific IP address, subnet and default gateway. Select it and click "Properties" to open the connection settings.

A new dialog will open, and there should be an item labelled “Internet Protocol Version 4 (TCP/IPv4)”.

Click on the appropriate network connection (see red box in example above).

VIRTUAL PORT DRIVER STM WINDOWS 10 WINDOWS

On Windows 7, use WIN-i and then find Network and Sharing Center

On the Windows computer, press WIN-x and select Network Connections, then click on “Network and Sharing Center”.

After a few seconds, the device will show its IP address on the built-in display, for example the number at the bottom (10.1.1.80) is the IP address of the MWM below.

Start the device - either by turning on the power switch or holding down the OK button for a few seconds.

For the MWM, power can be provided by USB connection to a computer USB port, or to a USB power adapter.

Connect device to Windows computer/laptop via standard ethernet patchcord (RJ45 to RJ45 connector).

These instructions assume an MWM but the instructions also apply for other ethernet-enabled MOGLabs devices.

VIRTUAL PORT DRIVER STM WINDOWS 10 PC

However, if you don't have a network you can plug new devices in (either because your institution does not allow unregistered devices, or there just isn’t a network), the easiest approach is to connect an ethernet cable directly between your PC and the MOGLabs device.

MOGLabs products will automatically detect the network configuration when plugged in and request an IP address from the network server.